BTDSys Stutter

Installation

Put BTDSys Stutter.dll in your Gear\Generators folder.

Notes

• There is an attribute to set whether the End/Length parameter sets the absolute end point, or the loop length (relative to the start point).
• If the end point is before the start point (or length is negative), the loop plays in the opposite direction to "normal".
• Inertia A applies to Start and End/Length, Inertia B applies to Loop Time, Rate and Volume.
• Only one of Loop Time or Rate is used at once (the one chosen by the Rate Par parameter). The other is just ignored.

Contact

If you have comments or suggestions, or if you find any bugs please email me.

Docs and code ⌐Ed Powley (BTDSys), June 2002